This is very strange problem I think. It was not in V1.
When I configure CCS3.0 with GB64 V2, CCS will not recognize my settet controller type. When starting a game, CCS will always take the Key Set1 and 2 configuration. But it is normaly set for Game Pad 1. When I run CCS stand alone, everything works fine.
The EXE for CCS in GEMUS setup is the same as in my original CCS folder.
What is going wron here? Please help me out of this mess.
Welcome to the Gamebase 64 forums. An attempt to document ALL Commodore 64 gameware before it's too late!
Problem with CCS64 controll config over GB64 V2
Moderator: Jimbo
- Michael Plate
- GB64 Team
- Location: Stockholm
Post
You have to modify the emulator related GEMUS script (lines 33-52) to set your desired settings for JoyPort1 and JoyPort2.
/Michael
/Michael
- Retroplay
- Cool Member
- Location: Denmark
Post
Ok this might sound stupid but here goes anyway.
Is there anyway to bypass the emulator scripts somehow and just use the control config in the CCS.cfg file?
I'm asking because I've been struggling to get it to work right.. without any luck.
As Proton mentioned before it works perfect if CCS64 3.0 is runned directly.
Is there anyway to bypass the emulator scripts somehow and just use the control config in the CCS.cfg file?
I'm asking because I've been struggling to get it to work right.. without any luck.
As Proton mentioned before it works perfect if CCS64 3.0 is runned directly.
Who is online
Users browsing this forum: Bing [Bot] and 4 guests